• No results found

Comparison of different types of photo voltaics at one site

N/A
N/A
Protected

Academic year: 2021

Share "Comparison of different types of photo voltaics at one site"

Copied!
1
0
0

Loading.... (view fulltext now)

Full text

(1)

Linnaeus ECO-TECH 2016 Kalmar, Sweden, November 21-23, 2016

35

COMPARISON OF DIFFERENT TYPES OF

PHOTO VOLTAICS AT ONE SITE

Torbjörn Skytt

Morgan Fröling

Mid Sweden University,

Sweden

Abstract

In May 2015 A4 Campus AB made a 30 kWp solar cell installation in cooperation with Mid Sweden University at one of the university buildings in Östersund. Four different types of solar cells were being installed each type with a power of about 7 kW; two types of polycrystalline silicon panels, one monocrystalline silicon type and one thin film (CuInSe2) type. The three types of crystalline panels were equipped with individual optimizers making individual panel follow up possible. A one year evaluation shows the installed thin film panels produces more electricity (as Wh per installed W) than do any of the installed crystalline types. The efficiency of the thin film panels is relatively higher compared to the crystalline panels those days when the insolation is lower, which might indicate future climate change should be taken into consideration when choosing which type of solar cells to install (for northern Sweden more rain is being predicted). Each one of the crystalline types are installed as a matrix with 2 or 3 rows. The lowest rows of each type produces more electricity compared to the row above. This might be caused by an increased temperature of the air flow behind the panels. However, during the period November to April the production especially of the lower rows is reduced due to snow coverage. For multiple row installation this phenomenon should be taken into consideration for calculations for optimal layout (1,7-1,9% reduction per row for 3 rows).

Out from the follow-up made it can be seen that the evaluation of offers from different manufactures is rather complex and the yearly production cannot be easily calculated of from the specified efficiency. A 6% difference in power output from crystalline types can be seen at an insolation close to 1.000 W/m2 and the difference in efficiency given in the specifications is in the range 15,2% to 15,8%.

References

Related documents

Stöden omfattar statliga lån och kreditgarantier; anstånd med skatter och avgifter; tillfälligt sänkta arbetsgivaravgifter under pandemins första fas; ökat statligt ansvar

46 Konkreta exempel skulle kunna vara främjandeinsatser för affärsänglar/affärsängelnätverk, skapa arenor där aktörer från utbuds- och efterfrågesidan kan mötas eller

För att uppskatta den totala effekten av reformerna måste dock hänsyn tas till såväl samt- liga priseffekter som sammansättningseffekter, till följd av ökad försäljningsandel

Coad (2007) presenterar resultat som indikerar att små företag inom tillverkningsindustrin i Frankrike generellt kännetecknas av att tillväxten är negativt korrelerad över

Generella styrmedel kan ha varit mindre verksamma än man har trott De generella styrmedlen, till skillnad från de specifika styrmedlen, har kommit att användas i större

Närmare 90 procent av de statliga medlen (intäkter och utgifter) för näringslivets klimatomställning går till generella styrmedel, det vill säga styrmedel som påverkar

Den förbättrade tillgängligheten berör framför allt boende i områden med en mycket hög eller hög tillgänglighet till tätorter, men även antalet personer med längre än

På många små orter i gles- och landsbygder, där varken några nya apotek eller försälj- ningsställen för receptfria läkemedel har tillkommit, är nätet av