Fredrik Agholme

WHFKQLTXHV DUH SURPLVLQJ IRU UHODWLQJ WKH ERQG JHRPHWULFDO SURSHUWLHV ZLWK

These points where: the centre stitch holding the support fabric at the top and bottom, the upper and lower ends of the centre stitch line for horizontal tear specimens and the far

Multilayer forming techniques are most commonly used in the manufacturing of paper board where chemical pulps with higher strength and better printing properties is placed on the

There was a small but significant increase in MBP at night in both dofetilide exposed offspring and controls of about 3.7% compared to before stress, but the differences

Using an ammonium sensor located in the last aerated basin for feedback control of the influent flow rate is the control strategy that gives the largest reduction in the

PCA is defined as a multivariate projection method designed to extract and display the systematic variation in a data matrix, whereas PLS is a regression extension of PCA which is

Local Load Predictions: Given that the load is highly prevalent in 30 − 40% of the kernel features we evaluate how well the load, x i [n ? ] predicts the load component of the

Injury mortality in Sweden; changes over time and the effect of age and