Quick setup guide
7050B
Suggested Tone
Control settings
Note:
Distance from front wall
Aligning the subwoofer
Subwoofer placement
D
D
A
B
10 cm (4)
Main
speaker
110 cm (43)
60 cm (24)
60 cm (24)
10 cm (4)
10 cm (4)
Positioning too far from the wall may
cause a loss in low frequency response
C
1) Positions A and B are recommended.
2) Position C causes a significant bass
boost and may cause asymmetrical
spatial imaging one subwoofer is used.
3) Positions C and D may also work, but
may cause loss of LF when off room
center axis.
C
Genelec Document BBAQS7050B001. Copyright Genelec Oy 5.2005. All data subject to change.
Position
A, B and D
-2 dB
Position C
-4 dB
Bass
Roll-Off
LFE BANDWIDTH LFE + 10 dB 120 ON 85 Hz ROLL-OFF -180° -90° PHASE -6 dB -4 dB -2 dB -270° 1234567 LFE BANDWIDTH LFE + 10 dB 120 ON 85 Hz ROLL-OFF -180° -90° PHASE -6 dB -4 dB -2 dB -270° 1234567Input
sensitivity
0
+6
+12
+3
-3
-6
-4
0
+6
+12
+3
-3
-6
-4
5.1 Connection and Wiring
Phase alignment
LFE channel
reproduced
up to 85 Hz
LFE channel
reproduced
up to 120 Hz
Subwoofer
Subwoofer
85 Hz
120 Hz
Setting the LFE channel reproduction bandwidth
LFE
BANDWIDTH
LFE + 10 dB
120
ON
85 Hz
ROLL-OFF
-180°
-90°
PHASE
-6 dB
-4 dB
-2 dB
-270°
1 23 4 567LFE
BANDWIDTH
LFE + 10 dB
120
ON
85 Hz
ROLL-OFF
-180°
-90°
PHASE
-6 dB
-4 dB
-2 dB
-270°
1 23 4 567 LFE BANDWIDTH LFE + 10 dB 120ON
85 HzROLL-OFF
-180° -90°PHASE
-6 dB -4 dB -2 dB -270° 1234567 LFE BANDWIDTH LFE + 10 dB 120ON
85 HzROLL-OFF
-180° -90°PHASE
-6 dB -4 dB -2 dB -270° 1234567 LFE BANDWIDTH LFE + 10 dB 120ON
85 HzROLL-OFF
-180° -90°PHASE
-6 dB -4 dB -2 dB -270° 1234567 LFE BANDWIDTH LFE + 10 dB 120ON
85 HzROLL-OFF
-180° -90°PHASE
-6 dB -4 dB -2 dB -270° 12345671.
Connect a loudspeaker to
the "FRONT CENTER" output
of the subwoofer and feed an
85 Hz test signal to the
"FRONT CENTER" input
3.
Toggle the subwoofers
dip switch 4 on and off and
set it to the position which
gives the lowest sound level
at the listening position.
4.
Set dip switch 5 to the
opposite setting.
2.
Toggle the subwoofers
dip switch 5 on and off
and set it to the position
which gives the lowest sound
level at the listening position.
Genelec Document BBAQS7050B001. Copyright Genelec Oy 5.2005. All data subject to change.
Quick setup guide
7050B
L
C
R
R L
RR
LFE
MADE IN FINLAND7050B ACTIVE SUBWOOFER
MAGNETICALLY SHIELDED www.genelec.comFRONT
LEFT
dBu
LFE IN
LFE BANDWIDTH LFE + 10 dB -6 SENSITIVITY FOR 100 dB SPL @ 1m 0 +6 +3 +12 -3 -4 120 ONFRONT
RIGHT
FRONT
CENTER
REAR
LEFT
REAR
RIGHT
POWER SERIAL NUMBER MAINS INPUT 50 / 60 Hz 120 W 230 V~IN
OUT
CAL POSITION ALL CONTROLS : OFF INPUT SENSITIVITY : -6dBu REFER TO THE OPERATING MANUAL FOR SUGGESTED CONTROL SETTINGS. FOR A FLAT FREE FIELD RESPONSE SET ALL TONE CONTROLS TO OFF. USING THE TONE CONTROLSON
BASS ROLL-OFF dB 25Hz ALL OFF 0 -2 -6 -4 85Hz 85 Hz ROLL-OFF -180° -90° PHASE -6 dB -4 dB -2 dB -270° WARNING ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. USE EARTHED MAINS CONNECTION ONLY.RISQUE DE CHOC LECTRIQUE. NE PAS OUVRIR. NE PAS EXPOSER À L'EAU OU L'HUMIDIT . AUCUN COMPOSANT À L'INT RIEUR REMPLAÇABLE PAR L'UTILISATEUR. ADRESSER TOUTE R PARATION À UN PERSONNEL QUALIFI . CET APPAREIL DOIT ÊTRE RACCORD À LA TERRE.